How to Measure for Box Beams
Box beams are made to order, so good measurements are the first step. This guide shows what to measure, how to send it, and how we use it to plan your beams. All you need is a tape measure, a ladder and your phone.
Not sure about something? Send what you have and photos of the room. We help you plan the rest.
Call (213) 715-5197 or send your measurements.
Part of our reclaimed wood box beams and ceiling beams.
What you need
- A tape measure (a long one for big rooms)
- A ladder, for the ceiling height and existing beams
- Your phone, for photos of every wall and the ceiling
- Paper or notes on your phone
- A simple sketch of the room, if you can
Three numbers for every beam
- Width (W) in inches: the bottom face you see from below
- Height (H) in inches: how far the beam drops from the ceiling
- Length (L) in feet: wall to wall, or the run of the ceiling
Write them as W × H × L, for example: 4 beams, 8 × 6 in, 16 ft.
Step by step
- Measure the room. Length and width, wall to wall, in feet. Measure each side, because old rooms are not always square.
- Measure the ceiling height. On a flat ceiling, floor to ceiling. On a vaulted ceiling, measure at the walls and at the highest point.
- Choose the direction. Beams usually run across the shorter side of the room. On a vaulted ceiling they often follow the slope, with a ridge beam at the top.
- Choose how many beams. Decide the spacing, measured center to center. Mark it with tape on the floor and look up: it is easier to judge than on paper.
- Choose the beam size. Larger rooms and higher ceilings can take wider and deeper beams. Send photos and we suggest a size that fits the room.
- Note what is on the ceiling. Lights, fans, vents, sprinklers and speakers. Box beams are hollow, so wiring and small lights can go inside.
- Take photos. Every wall, the full ceiling, and any existing beam close up with the tape measure in the picture.
- Send it to us. Use the form on this page or call. We reply with a plan, a quote and the lead time.
Flat, vaulted or coffered ceilings
- Flat ceiling: beams run parallel across the room. Send room length, width and ceiling height.
- Vaulted or cathedral ceiling: beams follow the slope, often with a ridge beam and collar ties. Send the height at the walls and at the peak, and photos from both ends.
- Coffered ceiling: beams cross in a grid. Send the room size and how many squares you want in each direction.
Measuring an existing beam for a wrap
If you already have a steel, LVL or wood beam, measure its width, height and length, and send a close photo of the beam where it meets the wall. We fasten wood blocking to the beam and install a hollow reclaimed wood wrap over it, so it looks like a solid old timber.
More about reclaimed wood beam wraps for steel and wood beams.
Choose a surface
Every surface is made from real reclaimed wood. See each one up close: Hand hewn · Rough sawn · Smooth planed · Wire brushed · Hit or miss · Resawn · Weathered grey.
Send your measurements
Fill in what you know. Not sure? Choose "Not sure" and we help you plan. You can attach photos or a sketch of the ceiling.
Measuring FAQ
Ready to send your numbers?
Call (213) 715-5197 or use the form. See all reclaimed wood box beams and ceiling beams.
Beam surfaces: Hand hewn · Rough sawn · Smooth planed · Wire brushed · Hit or miss · Resawn · Weathered grey
More beam guides
What is a box beam · Rough sawn vs hand hewn beams · Solid reclaimed wood beams
Box beams by color: Whitewash · Grey · Natural · Brown · Dark (hand hewn; each page links to the other surfaces).